Invens H1 hang on logo cannot be flashed when PMT is selected onCM2 SP2 2.7

Dear

i manage to copy flash file of invens H 1, when trying to flash this flash file on Phone which hang on log , CM2SP2 can not flash the phone

Operation : Flash Firmware [ v2.07 ]

Setting : Update NVRAM : False
Setting : Force NVRAM : False
Setting : Update PMT : True

1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!

Wait for device …

Device Connected!
BootVersion : SPRD3
Boot : INF : INFINITY FW PACKAGE
Sending Init Boot …
Boot sent!
Kick FDL …
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup …
Port speed : 921600
Sending Flash Boot …
Boot sent!
Kick FLASH FDL …
FDL : Control transfered!

Boot Done!

PMTMng : Load PMT
PMTMng : 0x20
PMTMng : Update failed!
ERROR : 00000084:84000000FF7B7E00
SYS : OPERATION FAILED!

Error : Flashing failed!
Make sure device HW is ok, check battery and cable! Try hold BootKey at whole Flash Process

Reconnect Power/Cable!

when i unselect PMT update; the soft flash the phone till end but phone always hang on logo

Operation : Flash Firmware [ v2.07 ]

Setting : Update NVRAM : False
Setting : Force NVRAM : False
Setting : Update PMT : False

1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!

Wait for device …

Device Connected!
BootVersion : SPRD3
Boot : INF : INFINITY FW PACKAGE
Sending Init Boot …
Boot sent!
Kick FDL …
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup …
Port speed : 921600
Sending Flash Boot …
Boot sent!
Kick FLASH FDL …
FDL : Control transfered!

Boot Done!

FSIMG : prodnv.img
CODE : wmodem.bin
CODE : wdsp.bin
CODE : modem_wcn.img
CODE : boot_logo.bmp
CODE : fastboot_logo.bmp
CODE : logo2.bin
CODE : logo3.bin
CODE : logo4.bin
CODE : logo5.bin
CODE : boot.img
FSIMG : system.img
FSIMG : persist.img
FSIMG : sysinfo.bin
FSIMG : cache.img
CODE : recovery.img
FSIMG : userdata.img
UBOOT : u-boot.bin
UBOOT : u-boot-spl.bin
ERASE : WFLASH
ERASE : WCNFLASH
ERASE : MISC
Flashing finished!
Reconnect Power/Cable!

Done!
Elapsed: 00:04:25

https://ibb.co/dPqf4Y1
https://ibb.co/RbHnRzs

so please i need some suggestion

leroi

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top