redmi note6 pro tulip after disable screenlock dont work

hi to all here is full log
Device : Xiaomi Redmi Note 6 Pro
Operation : Disable Locks
Checking for existing devices…Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM23)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.7
Connecting to phone…OK
Waiting for response…OK
Init Handshake Sequence…OK
Hardware ID : E1C00C00 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21 F65BA3303834E1
Initializing Protocol…OK
Using Auto Loader Selection [1] Preparing Loader…Done
Sending Loader [8996_016]…Done
Executing Loader…OK
Detecting Chip Type…OK
Hardware : MSM8996, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
Payload Info : In: 262144 [4096], Out: 131072, Sector Size: 512
Reading Partition Table…OK
Reading Device Information…OK
Device : Xiaomi Redmi Note 6 Pro [tulip] Brand : xiaomi
Prod.Name : tulip
Software : OPM1.171019.011, V10.2.2.0.OEKMIXM [Mon Jan 14 20:43:07 WIB 2019] Android Ver. : 8.1.0
Patch Level : 2019-01-01
USERDATA : Encrypted
Disabling Android Locks…Done
Operation Finished.
QcFire Ver. 6.0

same ask always patternlock
thanks for all

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top